[Tutor] AttributeError: 'module' object has no attribute 'start'
Mark Lawrence
breamoreboy at yahoo.co.uk
Fri Jun 13 15:14:43 CEST 2014
On 12/06/2014 17:51, jason sam wrote:
> The last question i hadn't asked yet..and if u are not interested in
> answering the question then also refrain from commenting please!
>
> On Thu, Jun 12, 2014 at 9:47 PM, Mark Lawrence <breamoreboy at yahoo.co.uk
> <mailto:breamoreboy at yahoo.co.uk>> wrote:
>
> On 12/06/2014 05:51, jason sam wrote:
>
> Hi All,
> I am new to wxPython.I have made a simple GUI that contains a
> button and
> by pressing that button i am calling another .py
> file(top_block.py)...But i am getting error using the command:
>
> top_block.start()
>
> The error is:
>
> AttributeError: 'module' object has no attribute 'start'
>
> The code is as attached.I am using python 2.7.3.Any improvements
> in the
> code are also welcome.The same error is received when i
> use'top_block.run()'.Is there any alternative to this commands?
>
> Regards,
> Ali
>
>
> I suspect that you'll get better answers on the wxpython list,
> especially consdiering that you asked there all of two minutes
> before asking here.
>
> --
> My fellow Pythonistas, ask not what our language can do for you, ask
> what you can do for our language.
>
> Mark Lawrence
>
> ---
Please don't top post on this list. Please don't try telling me what to
do or not do. Thanks in anticipation.
--
My fellow Pythonistas, ask not what our language can do for you, ask
what you can do for our language.
Mark Lawrence
---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com
More information about the Tutor
mailing list