[New-bugs-announce] [issue37654] 2to3 no-ops on embeddable distribution

[Bill Collins]

New submission from Bill Collins <bilbocollins at gmail.com>:

Firstly, I'd acknowledge that expecting 2to3 to work on the embeddable distribution might be the problem, but the mode of failure is silent and delayed.

The problem is that 2to3 loads fix names by searching for files in a package that end in '.py' (https://github.com/python/cpython/blame/master/Lib/lib2to3/refactor.py#L30) which isn't much use on the embeddable distribution where everything is pre-comipled.

So, installing an sdist package that relies on 2to3 will succeed, but any attempt to then actually use the installed package will fail.

I'm not sure whether the correct behavior here might be to

1. Fix 2to3 to load from pyc files (explicitly enabling 2to3 based installation on embeddable)
2. Fix 2to3 to fail when no converters are found (or similar; explicitly *disabling* 2to3 based installation on embeddable).

Or something else entirely.

----------
components: 2to3 (2.x to 3.x conversion tool)
messages: 348304
nosy: Bill Collins
priority: normal
severity: normal
status: open
title: 2to3 no-ops on embeddable distribution
type: behavior
versions: Python 3.5, Python 3.6, Python 3.7, Python 3.8, Python 3.9

_______________________________________
Python tracker <report at bugs.python.org>
<https://bugs.python.org/issue37654>
_______________________________________