[Mailman-Developers] Re: Cloning listsZ
David Champion
dgc at uchicago.edu
Fri Apr 2 15:28:16 EST 2004
* On 2004.04.02, in <Pine.SOL.4.58L.0404021447280.16491 at copland.udel.edu>,
* "Mike Porter" <mike at UDel.Edu> wrote:
> Make the new list, then perhaps use config_list to dump the
> variables of the list to clone from, make changes, and then import
> into the new list, making the new list look a lot like the old
> list?
The last time I needed to do this, it was possible just to copy the
contents of .../lists/[listname] to .../lists/[newlistname] -- config.db
and all. I haven't played with an installation that has config_list, but
making some basic assumptions, that seems workable, too. However you'll
need the associated templates and digest index file and so on, too.
And don't forget to copy the archives, if that applies. Users tend to
get annoyed by that, but only after enough time has passed to make it
harder to do right.
--
-D. dgc at uchicago.edu NSIT University of Chicago
More information about the Mailman-Developers
mailing list