Unexpected timing results with file I/O

[rdahlstrom]

On Feb 4, 10:17 am, Steven D'Aprano <st... at REMOVE-THIS-
cybersource.com.au> wrote:
> After reading an earlier thread about opening and closing lots of files,
> I thought I'd do a little experiment.
>
> Suppose you have a whole lot of files, and you need to open each one,
> append a string, then close them. There's two obvious ways to do it:
> group your code by file, or group your code by procedure.
>
> # Method one: grouped by file.
> for each file:
>     open the file, append the string, then close it
>
> # Method two: grouped by procedure.
> for each file:
>     open the file
> for each open file:
>     append the string
> for each open file:
>     close the file
>
> If you have N files, both methods make the same number of I/O calls: N
> opens, N writes, N closes. Which is faster?
>
> Intuitively, the first method has *got* to be faster, right? It's got one
> loop instead of three and it doesn't build an intermediate list of open
> file objects. It's so *obviously* going to be faster that it is hardly
> worth bothering to check it with timeit, right?
>
> Well, I wouldn't be writing unless that intuitive result was wrong. So
> here's my test results:
>
> Method 1:
>
> >>> import timeit
> >>> names = ['afile' + str(n) for n in range(1000)]
> >>> T = timeit.Timer('''for name in names:
>
> ...     fp = open(name, 'a'); fp.write('xyz\\n'); fp.close()
> ... ''', 'from __main__ import names')>>> min(T.repeat(6, 500))
>
> 17.391216039657593
>
> Method 2:
>
> >>> for name in names:  # reset the files to an empty state.
>
> ...     fp = open(name, 'w'); fp.close()
> ...>>> T = timeit.Timer('''files = [open(name, 'a') for name in names]
>
> ... for fp in files:
> ...     fp.write('xyz\\n')
> ... for fp in files:
> ...     fp.close()
> ... ''', '''from __main__ import names''')>>> min(T.repeat(6, 500))
>
> 16.823362112045288
>
> Surprisingly, Method 2 is a smidgen faster, by about half a second over
> 500,000 open-write-close cycles. It's not much faster, but it's
> consistent, over many tests, changing many of the parameters (e.g. the
> number of files, the number of runs per timeit test, etc.).
>
> I'm using Linux and Python 2.5.
>
> So, what's going on? Can anyone explain why the code which does more work
> takes less time?
>
> --
> Steven



The code that does more work takes more time.  The second one does
quite a bit less work.  Think of it like this:

You have 500,000 people to fit through a door.  Here are your options:

1.  For each person, open the door, walk through the door, then close
the door.
2.  Open the door, allow everyone to walk through, then close the
door.

Which one would you say would be a more efficient way to fit 500,000
people through the door?