[Mailman-Users] Setting a bind address for SMTP delivery
Mark Sapiro
mark at msapiro.net
Thu Feb 26 16:52:52 CET 2009
Brad Knowles wrote:
>Mark Sapiro wrote:
>
>> SMTPHOST and SMTPPORT in mm_cfg.py.
>
>That controls where you send to, but not what address Mailman binds to when
>it sends to that host/port.
Right. I misread the OP. It said "I think the simplest would be if I
could control the address from which mailman sends it's mail, say if
mailman binds to 127.0.0.2 instead of 127.0.0.1 when it sends it's
mail."
I read that as "... control the address to which mailman sends ...",
thinking that Karl would then change Postfix behavior based on the IP
the mail arrives at.
However, I too am puzzled as to why there are unqualified non-local
addresses to deal with at all.
--
Mark Sapiro <mark at msapiro.net> The highway is for gamblers,
San Francisco Bay Area, California better use your sense - B. Dylan
More information about the Mailman-Users
mailing list